Electric ovensBake and Broil Elements
A bake element with a blister, a split or a bright spot that flares and dies has burned through. The technician confirms it with a resistance reading and replaces it, including hidden bake elements tucked under the oven floor.
- Element resistance and ground test
- Hidden bake element access and swap
- Broil element and terminal check
Gas ovensBake and Broil Igniters
When you hear the oven try, see a glow, but never get flame, the igniter is likely drawing too little current. An amperage draw test with a clamp meter tells the technician in minutes, and the broil igniter gets checked the same way.
- Igniter amperage draw test
- Gas safety valve check
- Broil igniter diagnosis
TemperatureSensor, Calibration and Hot or Cold Ovens
Recipes failing at the right setting point to the oven sensor or the control. The technician reads the RTD resistance, runs the oven with a thermocouple probe in the center rack, and adjusts the temperature offset if the hardware tests good.
- RTD sensor resistance test
- Thermocouple probe temperature check
- Calibration and offset adjustment
Self-cleanDoor Locks and Thermal Fuses
Ovens often fail during or right after self-clean. The lock motor can jam with the door shut, or the thermal fuse can blow and kill power to the whole oven. The pro tests the motor, the switch and the fuse before quoting.
- Door lock motor and switch test
- Releasing a door stuck locked
- Thermal fuse and wiring check
ConvectionConvection Fan and Element
Noise from the back wall or uneven browning in convection mode points to the fan motor or the ring element around it. The pro checks motor windings and element continuity with the panel off.
- Fan motor winding and bearing check
- Convection element continuity
- Fan blade and rear panel inspection
Controls and doorControl Boards, F-Codes, Hinges and Gaskets
The technician reads the fault code, checks the relay outputs and wiring, and only replaces the board when tests point there. Door hinges and the fiberglass or silicone gasket are inspected too, since a poor seal wastes heat.
- Fault code and relay output testing
- Control or relay board replacement
- Door hinge and gasket replacement